Ram 1500 Intermediate Axle Shaft Repair 1220925

1220925

Dodge Ram 1500 axle shaft repair 

Same as 1220925, 1220925BK, 722N695BK, 722N695BKA, AXK842, 190424

 Known as:

Ram 1500 right side front axle shaft

Ram 1500 right side front intermediate  shaft

Ram 1500 front axle shaft

Ram 1500 axle repair kit

Instructions: Removing Right Side Housing:

• Remove PS housing by pulling top ball joint and outer tie rod end.
• Remove axle nut and tap CV axle off of the differential output shaft then remove from the hub and set aside.
• Next, unplug the actuator
• 2 Mounting bolts and 4 housing bolts need to be removed. With a small flat screwdriver and a hammer, break the silicone seal of the housing to the main part of the diff.

With the housing removed:

• Remove actuator and collar.
• Remove large inside snap ring (located in the actuator opening), then hit shaft with rubber mallet out of the housing.
• Remove the small snap ring off the shaft and reuse it on the new shaft.
• Use a suitable tool to remove the outer seal and caged needle bearing. (If the seal is not being replaced then inspect and clean the bearing and seal surface. Then apply a suitable grease to both.)
• Press the caged needle bearing in from the outside edge flush with the shoulder in the aluminum housing.
• Install assembled shaft and bearing assembly with press or rubber mallet until the inside snap ring groove is exposed and then re-install snap ring.
• Install the new seal (if removed) to an approx. and even depth of  .410” from the outer edge.
• Re-install steel dust shield. (inner lip may need to be resized with a flat disc and a hammer or a small set of pliers in order to retain the tension on the shaft.

Re-installing Housing:

• Reverse the order above ensuring the collar is in place. Apply a small bead of silicone around the flange of housing and re-install on the differential.
• The new ‘sure seal’ boot will need to be slid over the CV Axle first and then installed on the output shaft once the housing is re-installed.  (It seems to be easiest to work the entire boot over the axle first. The large then small end. This is a very tight fit, however, it will ensure a good seal)
• Grease splines well and once the CV axle is secured into place slide the small end of the boot off the CV axle and onto the output shaft, creating a seal to keep the moisture out and the grease in.  This should prevent the stripped axle from happening again.

Torque   Actuator-21 ft lbs        Housing Bolts-48 ft lb        Oil  75w85 (Top off as needed)